Cost Guides › Pricing
Replacing one shower glass panel in San Diego runs $280 to $1,100, against $1,450 to $2,600 for a whole new frameless door. If the hardware is sound, a single panel is by far the cheaper answer, and it is what we recommend most of the time.
| Panel Type | Typical Installed Price | Notes |
|---|---|---|
| Sliding door glass with existing frame | $280 - $650 | Cheapest replacement. Glass swapped into the frame that is already there. |
| Fixed frameless panel, 3/8 inch | $350 - $750 | No moving parts, so no hinge load to worry about. |
| Frameless door panel, 3/8 to 1/2 inch | $500 - $1,100 | Door glass carries the hinge load and has drilled holes, which is why it costs more. |
| Patterned or frosted glass | +15% to 30% | Obscure patterns cost more and lead time is longer. |
| Tinted glass (bronze, gray) | +15% to 30% | Matching an existing tint is not always exact on older glass. |
| Low-iron panel | +$120 to +$350 | Removes the green edge so a new panel blends with low-iron glass that stayed. |
| Curved panel replacement | $900 - $2,200 | Bent glass. Needs re-templating, and the radius must match the original. |
| Item | Added Cost | Why |
|---|---|---|
| Edge profile mismatch | +$80 to +$250 | A flat-polished edge next to a polished edge is visible. We match the original. |
| Hole pattern re-drilling | included | Hinge notches and handle holes are cut to the existing hardware pattern, not a generic one. |
| Bent or tempered specialty glass | +$300 to +$1,200 | Bending and specialty tempering are separate fabrication steps with longer lead times. |
| Hardware replacement while we are in there | +$90 to +$400 | If a hinge is bent or a roller is shot, replacing it now avoids a second visit. |
| Removal of broken tempered glass | +$80 to +$200 | Tempered glass breaks into thousands of pieces. Cleanup is real work. |
Ranges reflect actual San Diego County installs. Your quote is firm and in writing after templating.
Tempered glass stores internal stress. A nick at the edge or a star crack can release the whole panel without warning, sometimes days later. Tape is not a fix and no reputable shop will seal over it.
Hard water chemically etches the surface. Once it is scarred, polishing removes glass and leaves a wavy surface. Replacement is the only real answer in a hard-water city like San Diego.
Seal failure between panes cannot be repaired. The unit is replaced.
Tempered glass must be cut, edged, drilled, and tempered to order. Typical turnaround is 7 to 12 business days, longer for tinted, patterned, low-iron, or curved panels. The swap itself is usually under two hours.
Close, usually not exact. Dye lots and manufacturers change. If the two panels sit side by side the difference can show in bright light. We tell you that before ordering.
Sometimes, depending on the cause and your deductible. Most homeowners pay out of pocket because the panel costs less than the deductible.
One panel, nearly always, as long as the frame and hardware are sound. A full door only makes sense when the frame is corroded or the hardware is failing too.
Usually an edge chip that went unnoticed, or binding against the frame as the house settled. Tempered glass under stress fails suddenly and without a clear impact.
Serving San Diego and all of San Diego County. Templated on site, quoted in writing.
Free — no obligations